This solder mask and silk screen transport trolley is the covered version of the printing frame trolley. Solder mask screens and silk screens are carried upright in PP slot plates, and a transparent dust cover over the whole rack keeps dust, solder paste mist and overspray off the mesh while the frames wait between printing passes. Screens that are stored clean at the end of a shift start the next shift without a wipe-down, which matters where the mesh tension and emulsion quality decide the print result.
The frame is welded SUS304 stainless square tube, so it tolerates flux, cleaning agents and the humidity of a printing room without rusting. Slot plates are PP: they do not scratch the aluminium screen frame and they do not swell when wiped with a wet cloth. Slot spacing is set to the frame thickness in use, and plates can be swapped when a different screen size is introduced, so the trolley keeps working after a product change.
Capacity is rated at 150kg, which covers a full load of large screens plus the cover frame. Four 4 inch silent casters roll the trolley between the printing machines, with brakes on two wheels so it stays put while a screen is slid out. Because screens are inserted upright rather than stacked flat, the emulsion face is not pressed against another surface during transport.
A grounding kit can be added where the trolley stands inside an ESD protected area, and a label holder is fitted on the end frame so each trolley can be marked with its screen set or product code.
Key Features
- Transparent dust cover keeps dust and paste mist off stored screens, with zip or hook-and-loop access
- SUS304 square tube frame resists flux, cleaning agents and humid printing rooms
- 25 PP slot plates hold screens upright, spacing set to your frame thickness
- 150kg load capacity for a full set of large screens plus the cover frame
- Swap-in slot plates when the screen size changes, no new trolley needed
- 4 inch silent casters with brakes on two wheels
- Upright storage keeps the emulsion face clear of other surfaces during transport
- Optional ESD grounding kit and end label holder for screen set identification
Technical Specifications (Standard Version, All Customizable)
| Parameter | Detail |
|---|
| Product Name | Dust Cover Solder Mask Screen Transport Trolley |
| Model Number | KTD-T-007D |
| Material | SUS304 stainless square tube frame with PP slot plates |
| Slot Plates | 25 PP slots standard, spacing and count customizable |
| Dust Cover | Transparent PVC cover with zip or hook-and-loop access |
| Load Capacity | 150kg |
| Dimension (L*W*H) | 1300*700*1150mm, customizable |
| Caster | 4 inch silent casters, brakes on two wheels |
| Grounding | ESD grounding kit optional |
| Application | SMT printing room, solder mask and silk screen storage and transfer |
| MOQ / Delivery | 5 sets / 15-20 working days after deposit |
When to Choose the Covered Version
Choose the covered version when screens are stored for hours or days between runs, when the printing room is dusty or shares air with a wave solder or coating line, when the screen set for a product has to travel between two buildings, or when a full load of large screens exceeds the 100kg rating of the standard trolley. For a trolley that is loaded and unloaded within the same shift in a clean room, the open version is the lower cost choice.
Notes
Before ordering: confirm screen size and frame thickness, required slot count and spacing, load weight and cover type; a drawing is issued for approval before production. During use: keep the load within 150kg and screens fully seated in the slots, close the cover when the trolley is parked, lock the casters before sliding a screen out, and wipe the PP plates with a non-abrasive cleaner at planned intervals.
Your message must be between 20-3,000 characters!