Double Sided Gravity Flow Rack Steel Roller Four Tier 250kg Per Layer for Two Line Side Picking Stations

This double sided gravity flow rack puts two picking faces on one frame. Each tier is split by a central divider into two opposing gravity lanes: containers are loaded from the aisle side, roll forward on steel rollers to the picking face, and are taken out in the order they were loaded. One rack therefore serves two work stations standing back to back, which is common where two short assembly lines run parallel and neither has room for its own flow rack along the aisle.

The frame is industrial aluminium profile with an anodised finish, assembled from modular sections so height, tier count and lane length can be changed later. Steel rollers carry cartons and heavier bins that would deform a plastic roller; engineering plastic rollers remain available where quiet running matters more than load. Lane slope is set per tier, so a lane feeding light trays can run flatter than one feeding full cases.

Load is rated at 250kg per layer evenly distributed, and each lane ends in a stop plus a label holder so the picking face is marked with the part number and the kanban card sits with the lane it belongs to. A centre divider stops containers from crossing to the opposite face, and end stops at the loading side stop a case from being pushed straight through.

Legs finish in levelling feet for a fixed installation. Casters with brakes can be specified when the rack has to be moved during a line changeover, and an overhead pipe rail can be added to hang tools or a work instruction document at the picking face.

• Two picking faces on one frame, serving two parallel stations back to back
• Steel rollers for cartons and heavier bins, plastic rollers optional for quiet running
• 250kg per layer evenly distributed, four tiers standard
• Central divider and end stops keep containers in their own lane
• Per-tier slope adjustment to match tray and case weight
• Label holders at every picking face for part number and kanban cards
• Anodised aluminium profile frame, modular and re-configurable after delivery
• Levelling feet standard, braking casters and pipe rail accessory optional

Choose the double sided version when two stations share one aisle, when floor width only allows one rack but two lines need picking faces, or when the same component family has to be presented to two shifts working back to back. For a single picking face along one aisle, the standard single sided roller flow rack is the lower cost choice.